Cisco Certified Network Associate Data Center 200-150 Exam Questions Are Out – Download And Prepare
Different learning methods of Introducing Cisco Data Center Networking Cisco 200-150 exam are used in the software to ease the candidates learning of difficult concepts and they are facilitated for learning Introducing Cisco Data Center Networking Cisco 200-150 exam with the simulated real Certified Cisco 200-150 exam scenarios so that you can practice in the same situation that you are going to face in the real exam.Cisco 200-150 exam Practice test software evaluates the performance by using self-assessment and report feature.
|Full Exam Name||Introducing Cisco Data Center Networking|
|Certification Name||Cisco Certified Network Associate Data Center|
|Technology||Data Center Management|
♥ 2019 Valid 200-150 Exam Questions ♥
200-150 exam questions, 200-150 PDF dumps; 200-150 exam dumps: 200-150 Exam Questions (271 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)
Latest and Most Accurate Cisco 200-150 Exam Questions:
A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the network administrator is using for this operation?
F. data link
FTP belongs to Application layer and it is also the highest layer of the OSI model.
Refer to the exhibit.
After HostA pings HostB, which entry will be in the ARP cache of HostA to support this transmission?
A. Exhibit A
B. Exhibit B
C. Exhibit C
D. Exhibit D
E. Exhibit E
F. Exhibit F
Host A knows host B is in another network so it will send the pings to its default gateway 192.168.6.1. Host A sends a broadcast frame asking the MAC address of 192.168.6.1. This information (IP and MAC address of the default gateway) is saved in its ARP cache for later use.
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC
Modern Ethernet networks built with switches and full-duplex connections no longer utilize CSMA/CD. CSMA/CD is only used in obsolete shared media Ethernet (which uses repeater or hub).
A receiving host computes the checksum on a frame and determines that the frame is damaged. The frame is then discarded. At which OSI layer did this happen?
D. data link
The Data Link layer provides the physical transmission of the data and handles error notification, network topology, and flow control. The Data Link layer formats the message into pieces, each called a data frame, and adds a customized header containing the hardware destination and source address. Protocols Data Unit (PDU) on Datalink layer is called frame. According to this question the frame is damaged and discarded which will happen at the Data Link layer.
Which of the following correctly describe steps in the OSI data encapsulation process? (Choose two.)
A. The transport layer divides a data stream into segments and may add reliability and flow control information.
B. The data link layer adds physical source and destination addresses and an FCS to the segment.
C. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D. Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E. The presentation layer translates bits into voltages for transmission across the physical link.
Answer: A, D
New Updated 200-150 Exam Questions 200-150 PDF dumps 200-150 practice exam dumps: https://www.dumpsschool.com/200-150-exam-dumps.html