FORTINET NSE7 Exam Questions – Latest 2017

Different learning methods of Fortinet Network Security Expert NSE7 exam are used in the software to ease the candidates learning of difficult concepts and they are facilitated for learning FORTINET Troubleshooting Professional NSE7 exam with the simulated real Certified FORTINET NSE7 exam scenarios so that you can practice in the same situation that you are going to face in the real exam. FORTINET Networking Management NSE7 exam Practice test software evaluates the performance by using self-assessment and report feature.

Latest and Most Accurate FORTINET NSE7 Dumps Exam Q&As:

Version: 9.0
Question: 1

Which three rule types are available when defining policies in Panorama? (Choose three.)

A. Pre Rules
B. Post Rules
C. Default Rules
D. Stealth Rules
E. Clean Up Rules

Answer: ABC


Question: 2

A network design calls for a “router on a stick” implementation with a PA-5060 performing inter-VLAN routing All VLAN-tagged traffic will be forwarded to the PA-5060 through a single dot1q trunk interface. Which interface type and configuration setting will support this design?

A. Trunk interface type with specified tag
B. Layer 3 interface type with specified tag
C. Layer 2 interface type with a VLAN assigned
D. Layer 3 subinterface type with specified tag

Answer: D

Question: 3

New Updated NSE7 Exam Questions NSE7 PDF dumps NSE7 practice exam dumps: (45 Questions)

Examine the partial output from the IKE realtime debug shown in the exhibit; then answer the question below.

Why didn’t the tunnel come up?

A. IKE mode configuration is not enabled in the remote IPsec gateway.
B. The remote gateway’s Phase-2 configuration does not match the local gateway’s phase-2 configuration.
C. The remote gateway’s Phase-1 configuration does not match the local gateway’s phase-1 configuration.
D. One IPsec gateway is using main mode, while the other IPsec gateway is using aggressive mode.

Answer: B

Question: 4

Four FortiGate devices configured for OSPF connected to the same broadcast domain. The first unit is elected as the designated router The second unit is elected as the backup designated router Under normal operation, how many OSPF full adjacencies are formed to each of the other two units?

A. 1
B. 2
C. 3
D. 4

Answer: B

Question: 5

The logs in a FSSO collector agent (CA) are showing the following error: failed to connect to registry: PIKA1026 ( What can be the reason for this error?

A. The CA cannot resolve the name of the workstation.
B. The FortiGate cannot resolve the name of the workstation.
C. The remote registry service is not running in the workstation
D. The CA cannot reach the FortiGate with IP address

Answer: C

Question: 6

Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the above output? (Choose two.)

A. The port4 interface is connected to the OSPF backbone area.
B. The local FortiGate has been elected as the OSPF backup designated router
C. There are at least 5 OSPF routers connected to the port4 network.
D. Two OSPF routers are down in the port4 network.

Answer: BD