Question No. 1

Refer to the exhibit.

You want router R1 to perform unequal-cost routing to the 192.168.10.0/24 network. What is the smallest EIGRP variance value that you can configure on R1 to achieve this result?

• A. 1
• B. 2
• C. 3
• D. 4

Question No. 2

Which two OSPF router types can perform summarization in an OSPF network?(Choose two)

• A. backbone router
• B. area border router
• C. summary router
• D. a autonomous system boundary router
• E. internal router

Question No. 3

Which statement about stateless and tasteful IPv6 auto configuration is true?

• A. Both stateless and stateful configuration require additional setup.
• B. Stateless autofiguration requires no additional setup whereas stateful autoconnguration requires additional setup
• C. Stateless autoconftguraton requires additional setup whereas stateful autoconfiguration requires no additional setup.
• D. Both stateless and stateful autoconfiguration require no additional setup.

Question No. 4

Which task must you perform to enable a point-to-point Frame Relay connection?

• A. Enable inverse ARP.
• B. Configure the encapsulation type.
• C. Configure static address mapping.
• D. Disable inverse ARP.

Question No. 5

Configuration snippet that looks similar to this:

ip access-list 1 permit xx xx

ip nat inside source list 1 int fa0/0 overload

What is this an example of ?

• A. static NAT
• B. NAT64
• C. PAT
• D. dynamic NAT
• E. NPTv6

Question No. 6

Which three IP SLA performance metrics can you use to monitor enterprise-class networks?

(Choose three)

• A. connectivity
• B. packet loss
• C. traps
• D. bandwidth
• E. reliability
• F. delay

Question No. 1

Which three NTP operating modes must the ntp trusted-key command be configured on for authentication to operate properly?(Choose three)

• A. client
• B. interface
• C. stratum
• D. server
• E. peer
• F. broadcast

Question No. 2

Which statements best describes the following two OSPF commands, which are used to summarize routes?

area 0 range 192.168.110.0 255.255.0.0

summary-address 192.168.110.0 255.255.0.0

• A. The area range command defines the area where the network resides. The summary-address command
• B. The area range command defines the area where the network resides. The summary-address command
• C. The area range command specifies the area where the subnet resides and summarizes it to other areas.
• D. The area range command summarizes subnets for a specific area. The summary-address commandsummaries a subnet for all areas

Question No. 3

What percent of R1 interfaces bandwidth is ERIGRP allowed to use?

• A. 10
• B. 20
• C. 30
• D. 40

Question No. 4

What does SNMP v2c use for authentication?

• A. community string
• B. hash algorithm
• C. SSL certificate
• D. username and password

Question No. 5

Which two statements about NHRP in a DMVPN environment are true (Choose two.)

• A. It routes traffic through the tunnel.
• B. It provides address resolution to route traffic.
• C. It can authenticate VPN endpoints.
• D. It requires each endpoint to have a unique network ID.
• E. It can identify PIM-SM RPs over a tunnel.