Cisco 300-370 Exam Questions – Latest 2018

Different learning methods of Cisco Certified Network Professional Wireless 300-370 exam are used in the software to ease the candidates learning of difficult concepts and they are facilitated for learning Cisco Troubleshooting Cisco Wireless Enterprise Networks 300-370 exam with the simulated real Certified Cisco 300-370 exam scenarios so that you can practice in the same situation that you are going to face in the real exam. Cisco Wireless Network Solutions 300-370 exam Practice test software evaluates the performance by using self-assessment and report feature.

300-370 exam questions, 300-370 PDF dumps; 300-370 exam dumps:: https://www.dumpsschool.com/300-370-exam-dumps.html (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-370 Dumps Exam Questions and Answers:

Version 8.0
Question: 21

Which statement about the usage of the debug command in a Cisco Unified Wireless Network is true?

A. Debug is enabled until manual shut off.
B. Debug is a message logging severity 7.
C. Debug is a restricted command and is not available in the AP CLI.
D. Debug is available on the WLC serial console and web interface.

Answer: B

Question: 22

An engineer is deploying a wireless infrastructure and must use Layer 2 discovery for access point association. Which configuration meets this requirement?

A. Configure the Access Points and WLC management interface on the same VLAN.
B. Configure a DNS A RECORD to point to the controller.
C. Configure option 43 on The APs DHCP scope.
D. Configure the AP using a serial connection to indicate its controller.

Answer: A

Question: 23

New Updated 300-370 Exam Questions 300-370 PDF dumps 300-370 practice exam dumps: https://www.dumpsschool.com/300-370-exam-dumps.html

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two)

A. show sysinfo
B. show udi
C. show inventory
D. show boot
E. show tech-support

Answer: AB

Question: 24

While reviewing Clean Air data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting?

A. informational
B. major
C. minor
D. warning
E. critical

Answer: D

Question: 25

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

A. rogue AP containment
B. RF detection
C. switch port tracing
D. wire detection
E. Cisco Prime Infrastructure location services

Answer: A

Question: 26

Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages?

A. debug pm pki enable
B. debug cert events enable
C. debug capwap events enable
D. debug capwap packet enable
E. debug capwap errors enable

Answer: E