Cisco CCNA Routing & Switching 200-125 CCNA Exam – Pass Your Exam In First Attempt

Question No. 1

Which value is used to build the CAM table?

• A. Source ip address
• B. Destination ip address
• C. Destination MAC address
• D. Source MAC address

Question No. 2

Which algorithm is used for the frame check sequence in an Ethernet frame?

• A. SHA-1
• B. AES-256
• C. CRC
• D. MD5

Question No. 3

When you configure and boot a new device, when does the running configuration become active?

• A. When IOS is loaded into RAM
• B. When the startup configuration is copied into RAM
• C. Immediately after the power-on self-test.
• D. When the devices boots to ROMMON.

Question No. 4

Refer to the topology shown in the exhibit.

Which ports will be STP designated ports if all the links are operating at the same bandwidth? (Choose three.)

• A. Switch A -Fa0/0
• B. Switch A – Fa0/1
• C. Switch B – Fa0/0
• D. Switch B – Fa0/1
• E. Switch C – Fa0/0
• F. Switch C – Fa0/1

Question No. 5

Which two VLAN IDs indicate a default VLAN? (Choose two.)

• A. 0
• B. 1
• C. 1005
• D. 1006
• E. 4096

Question No. 6

Which two TLVs does LLDP support? (Choose two )

• A. native VLAN
• B. port duplex
• C. management address
• D. system description
• E. spanning tree

Question No. 7

Which two options are primary responsibilities of the APIC-EM controller? (Choose two.)

• A. It automates network actions between different device types.
• B. It provides robust asset management.
• C. It tracks license usage and Cisco IOS versions.
• D. It automates network actions between legacy equipment.
• E. It makes network functions programmable.