Dell DNDNS-200 Exam Questions – Latest 2018

Different learning methods of Dell Certified Professional DNDNS-200 exam are used in the software to ease the candidates learning of difficult concepts and they are facilitated for learning Dell Networking Professional DNDNS-200 exam with the simulated real Certified Dell DNDNS-200 exam scenarios so that you can practice in the same situation that you are going to face in the real exam. Dell Networking Management DNDNS-200 exam Practice test software evaluates the performance by using self-assessment and report feature.

♥ VALID DNDNS-200 Exam Questions 2018 ♥

DNDNS-200 exam questions, DNDNS-200 PDF dumps; DNDNS-200 exam dumps:: https://www.dumpsschool.com/DNDNS-200-exam-dumps.html (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest Dell DNDNS-200 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

Which three properties are required for two OSPF router interfaces to establish a neighbor relationship? (Choose three.)

A. Router interfaces must have the same OSPF timers.
B. Router interfaces must be on a point-to-point network.
C. Router interfaces must be in the same area.
D. Router interfaces must use the same OSPF process I
E. Router interfaces must be on the same primary IP subnet.

Answer: A,C,E

Question: 22

On an S-Series switch, what two events occur when a static null route has been configured in the system to drop a packet? (Choose two.)

A. Null route is installed in the PBR table to drop the packet
B. Null route is saved into the running configuration.
C. Null route is installed in the ACL table with deny statement.
D. Null route is installed in the IP forwarding table.

Answer: B,D

Question: 23

Refer to the exhibit.
A network engineer is called onsite to troubleshoot replication failure and traffic loss. Whenever replication occurs between SAN A and SAN B, users report traffic loss between sites, and replication ultimately fails due to traffic loss.
Based on the topology shown, what is the most likely cause of the traffic loss?

A. Traffic needs to be policed on the site border routers.
B. An inbound policy map needs to be defined on the site border that marks the replication traffic with a DSCP value of 46.
C. An outbound policy map needs to be defined on the site border that marks the replication traffic with a DSCP value of 46.
D. Traffic needs to be shaped on the site border routers.

Answer: C

Explanation:
In Quality of Service, DSCP value 46 is high-priority traffic.

Question: 24

Refer to the exhibit of the N-series switches.
The exhibit shows a Layer 2 network between Host A (a Desktop Computer running Windows 7) and Host B (another Desktop Computer running Windows 7) and the list of VLANs Untagged (U) and Tagged (T) at each Ethernet interface: Host A transmits an Ethernet frame untagged on VLAN 1.
What will happen to the Ethernet frame?

A. SW2 drops the Ethernet frame when trying to transmit it out of interface E2 because the incoming and outgoing interfaces are Tagging/Untagging VLAN 1 differently.
B. The Ethernet frame is successfully delivered to Host.
C. STP drops the Ethernet frame because it cannot create an end-to-end loop free path between the switches for VLAN 1.
D. VLAN consistency protocol determines that the VLAN is not correctly Tagged/Untagged on all interfaces, an error will occur, and SW1 will drop the frame on interface E2.

Answer: B

Question: 25

Refer to the exhibit.
Considering the network topology and information shown, what is an issue with end point devices in network 192.168.102.0/24 that try to route to 192.168.101.0/24?

A. ICMP Redirects
B. Suboptimal Routing
C. Routing Loop
D. Summarization Black Hole

Answer: C

Question: 26

Refer to the Exhibit.
A network engineer receives the output shown when removing MLAG from a pair of N-Series switches.
Which sequence of steps must the engineer complete to remove the vpc peer-link from Port Channel 1?

A. Shut down the Port Channel interfaceIssue the no vpc peer-link command on the Port Channel
B. Remove the vpc feature using the no feature vpc commandIssue the no vpc peer-link command on the Port Channel
C. Remove the channel-group command from all members of the Port ChannelIssue the no vpc peer-link command on the Port Channel
D. Remove peer-keepalive enable using the no peer-keepalive enable commandIssue the no vpc peer-link command on the Port Channel

Answer: D

New Updated DNDNS-200 Exam Questions DNDNS-200 PDF dumps DNDNS-200 practice exam dumps: https://www.dumpsschool.com/DNDNS-200-exam-dumps.html